Notice: The info below is not item specific.
Lifesafety Power Inc
All-in-one power solutions for 4-10 door Salto systems using CU42E0, CU4200, or CU4EB8 controllers. Single, dual voltage/Networked. Salto unified power systems offers maximum flexibility, functionality and savings to access system designers. Salto Unified enclosures are engineered to house Flexpower boards in one compact, secure system. This unit is a 75W 12V and 24V DC dual voltage access power system. The C4 lock control module provides four access control inputs capable of voltage or dry contact activation, and four fused outputs programmable for failsafe / fail secure operation at either 12 or 24 VDC and controlled by the integrated fire alarm interface circuit on the FPO. Salto access enclosures are painted steel with two removable controller backplates and include lock, two (2) keys and tamper switch.
Features:
FPO offline power supply:
120 or 230 VAC input
12 and 24 VDC outputs
On board fire alarm interface
Continuous and resettable DC
Distributed output module: Four lock control – fused at 3A each
Expansion options:
Increased power, multiple voltages
Additional distribution outputs
Network monitoring and reporting
Labor saving design:
Pre-wired power section
Pre-punched knockouts
Preinstalled brackets hold two Salto controllers
Flexible backplate mounting locations
Access panels mount on threaded studs – no drilling required
Additional benefits:
Wire management room
4.5″ enclosure depth fits battery set
Tamper switch, lock, dual key set standard
Mounting hardware for access boards included
Specifications:
Input Power:
Input 120/230 VAC 50/60 Hz | 83 Watts (0.69A)
Overload and short circuit protection
Over temperature protection
Polarized AC power supply disconnect
Output Power:
2A@12V and 2A@24V DC, 75W maximum combined output power
Outputs: Continuous (DC1) Resettable (DC2)
4 controlled outputs, fused at 3A each
120 mV output voltage ripple
System Efficiency: 83% | System BTU Rating: 33 BTU/Hr
Battery Charging:
Independent built-in 1A charger for sealed lead acid or gel type batteries
Microprocessor dual rate charging of 24 V battery sets
Automatic switchover to standby battery when AC fails
Zero delay when switching over to battery backup
Supervision: AC Fail (form “C” contacts) System fail (form “C” contacts) may be triggered by low/no battery, short to earth ground and power supply failure
Visual Indicators:
AC input, DC1 and DC2 output
System fault | AC fault | Short to earth ground | Reverse battery polarity
Fire Alarm Input activated
B100: DC input, output and Fault
C4: DC input, output and Fault
Enclosure Dimensions: Size: 14.00H x 12.00W x 4.50D in. (35.00 x 31.00 x 11.50 cm) | Weight: 14 lbs
Specifications
Specifications for Lifesafety Power Inc LSIFPO75-B100C4E1-2SL1
Other Specs
Alternate CodesFPO75B100C4E12SL1, FPO75-B100C4E1-2SL1
CategoryAccess Control, Alarm Power Supplies, Alarms & Intercom, Burglar Alarms, CCTV Products, Power Supplies, Wire & Power Supplies
Manufacturer: Lifesafety Power Inc | Part#: LSIFPO75-B100C4E1-2SL1
Ordering note: Use Hot# 196196 when placing orders.