Command Access
The MLRK1-FAL25 is a practical and cost-effective way to convert a mechanical Falcon 24/25 series device to an electrified latch pullback device. Our easy-to-install motor -driven kit installs in a matter of seconds with no drilling or screws required, a true “drop-in” kit! PTS allows for an easy post-installation adjustment of the latch/ latches. A built-in REX switch is standard on all units! Last but not least, features an updated MM4S module with 2 different energy consumption settings from energy conscious to high torque to get the tough jobs done!
Features:
MM4S Smart Module: On board diagnostics with audible feedback for adjustment and power issues
“PTS”: 5 second electronic adjustment for easy post installation adjustment
Electric dogging rated for continuous duty – auto re-engage if push pad is pulled from dogged position
Low current draw – field switchable to “high torque” mode
Up to 300’ wire run with 2-18ga wire – long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel
8’ cable with quick connect for MM4S module to easily connect to power supply lead
Request-to-exit kit available
3-year “no hassle” warranty
Models:
MLRK1-FAL25: Kit for Falcon 24/25 series. EU 24V w/REX
RDP-FAL25: Replacement dogging pin for fire rated devices
Specifications:
Voltage range: 24 to 28 VDC
System protection: unit shutdown when voltage exceeds 28VDC
Standard: Average current peak: 900mA, average current hold: 215mA
High Torque – Average Current Peak: 2A, average current hold: 250mA
PTS adjustment: approx. 1/4”
Specifications for Command Access CMAMLRK1-FAL25
Other Specs
Alternate CodesCMAFLP-UL-M-KIT, CMAFLP-UL-M-KIT REX, CMAFLP-UL-M-KIT-RX, MLRK1-FAL25, MLRK1FAL25
CategoryElectrified Exit Devices, Exit Devices & Exit Alarms
