Power Supply/Charger Board Only, Output 12/24VDC @ 6 Amp, Single Filtered and Electronically Regulated Output, Aux Output, FAI Fire Alarm Interface, LinQ2 Ready, Input: 120VAC, LED Visual Indicators

$415.63

1 in stock

SKU: ALXEFLOW6NB Category:

Notice: The info below is not item specific.
Altronix
EFLOW6NB Power Supply Charger, Single Output, 12/24VDC @ 6A, Aux Output, FAI, LinQ2 Ready, 115VAC, Board. UL Listed Sub-Assembly power supply/charger converts a 120VAC, 60Hz input into a single 12VDC or 24VDC output. It also offers a suite of Features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.
Features:
UL Listed For:
Access Control System Units (UL294).
Power Supplies for use with Burglar Alarm Systems (UL603).
Power Supplies for Fire Protective Signaling Systems (UL1481).
cUL Listed For:
CSA Standard C22.2 No.205-M1983, Signal Equipment.
CAN/ULC – s319-05, Electronic Access Control Systems.
ULC-S318-96 – Power Supplies for Burglar Alarm Systems.
Also suitable for Access Control.
Optional Accessories:
LINQ2: Network Supervision.
Altronix model LINQ2 Network Communication Module provides remote supervision, control and monitoring over LAN/WAN.
Remotely reports accurate power diagnostics.
Controls power and resets devices.
Reports system diagnostics via Email.
Specifications:
Input Rating:
Input 120VAC 60Hz, 3.5A.
Output:
12VDC or 24VDC selectable output.
6A continuous supply current.
Aux. power-limited output rated @ 1A (unswitched).
Over Voltage Protection.
Filtered and electronically regulated outputs.
Battery Backup:
Built-in charger for sealed lead acid or gel type batteries.
Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption.
Fire Alarm Disconnect:
Supervised Fire Alarm disconnect (latching or nonlatching) 10K EOL resistor. Operates on a normally open (NO) or normally closed (NC) trigger.
Supervision:
AC fail supervision (form “C” contacts).
Notification trigger is selectable for 30 seconds (factory set) or 2 hours.
Battery fail & presence supervision (form “C” contacts).
Low power shutdown. Shuts down DC output terminals if battery voltage drops below 80% of nominal. Prevents deep battery discharge.
Electrical:
Temperature: Operating: 0° C to 49° C (32° F to 120° F); Storage: – 20° C to 70° C ( – 4° F to 158° F).
Relative Humidity 85% +/- 5%
BTU/Hr (approx.): 12VDC: 37 BTU/Hr.; 24VDC: 74 BTU/Hr.
System AC input VA requirement: 420VA.
Visual Indicators:
Green AC Power LED indicates 120VAC present.
AC input and DC output LED indicators.
Additional Features:
Short circuit and overload protection.
Dimensions (W x L x H):
4.6″(116.84mm) x 7.5″(190.5mm) x 1.75″(44.45mm).
Weight:
Product Weight: 0.8 Lbs. (0.36 kg).

Specifications

Specifications for Altronix ALXEFLOW6NB
Other Specs
Alternate CodesEFLOW6NB
CategoryAccess Control, Alarm Power Supplies, Alarms & Intercom, Burglar Alarms, CCTV Products, Power Supplies, Wire & Power Supplies

Manufacturer: Altronix   |   Part#: ALXEFLOW6NB

Ordering note: Use Hot# 178036 when placing orders.