Threshold Bolt for Use with MS1850 Deadbolt Active Door Leaf 2 Point Locking, Includes Bolt Guide, Cylinder Height Below 53in

Adams Rite Manufacturing

Security for pairs of doors with single key turn is possible with the 4015 threshold bolt. The two-point locking solution secures the entire double door entrance when working in conjunction with an MS deadlock. Adding the 4015 Threshold Bolt to a pivoted bolt MS deadlock provides maximum security for pairs of doors with the turn of a single key. Simultaneously dropping a stainless steel hex bolt into the threshold and pivoting the massive MS bolt into the mating door’s stile, the two-point locking solution secures the entire entrance. The 4015 threshold bolt is harnessed to the rear of the pivoted bolt. It may be added to any basic MS1850S, MS1850SN, MS1950 series deadlock. Both the 4015 threshold bolt and the 4016 header bolt may be added to a pivoted bolt MS deadlock to provide maximum security for pairs of doors by the turn of a single key. Simultaneously extending the stainless steel hex bolts into the threshold and header and pivoting the massive MS bolt into the mating door’s stile, thereby providing a three-point locking solution. 360° turn of key or thumbturn in basic MS deadlock throws counterbalanced bolt into opposite door and drops bolt into threshold. Key can be removed only when bolts are in a positively locked or unlocked position.

Specifications:

• Cylinder Height: Standard threshold bolt rod is sufficient for cylinder height up to 53-7/16″ [1357.3 mm]. It is fully threaded and can be cut off for low cylinder heights.
• Adjustment: Exact adjustment of threaded rod to cylinder heights is locked in place by hexagonal threshold bolt.
• Strike: For drop-bolt, a 1/2″ [12.7 mm] diameter hole in metal threshold is suitable. For non-metal installation, 4005 strike is available separately.
• Threshold Bolt: Hexagonal 3/8″ [9.5 mm] flat to flat. Made of stainless steel.
• Options: For “universal” application, specify 4015-18-IB with fully threaded rod for cut off to any cylinder heights below 53″ [1346.2 mm]. Please contact factory for cylinder height greater than 53″ [1346.2 mm] to maximum 60″ [1524mm] or to specify rods pre-cut to specific cylinder heights available by special order for high volume applications.